↓ Skip to main content

High-Performance Nanowire Hydrogen Sensors by Exploiting the Synergistic Effect of Pd Nanoparticles and Metal–Organic Framework Membranes

Overview of attention for article published in ACS Applied Materials & Interfaces, September 2018

About this Attention Score

  • Above-average Attention Score compared to outputs of the same age (59th percentile)
  • Good Attention Score compared to outputs of the same age and source (66th percentile)

Mentioned by

twitter
1 X user
patent
2 patents

Readers on

mendeley
121 Mendeley
You are seeing a free-to-access but limited selection of the activity Altmetric has collected about this research output. Click here to find out more.
Article details
Title
High-Performance Nanowire Hydrogen Sensors by Exploiting the Synergistic Effect of Pd Nanoparticles and Metal–Organic Framework Membranes
Published in
ACS Applied Materials & Interfaces, September 2018
DOI 10.1021/acsami.8b12569
Pubmed ID
Authors
Abstract

Herein, we report the fabrication of hydrogen gas sensors with enhanced sensitivity and excellent selectivity. The sensor device is based on the strategic combination of ZnO nanowires (NWs) decorated with palladium nanoparticles (Pd NPs) and a molecular sieve metal-organic framework (MOF) nanomembrane (ZIF-8). The Pd NPs permit the sensors to reach maximal signal responses, whereas the ZIF-8 overcoat enables for an excellent selectivity. Three steps were employed for the fabrication: (i) coating of a miniaturized sensor with vapor-grown ZnO NWs, (ii) decoration of these NWs with Pd NPs by atomic layer deposition, and (iii) partial solvothermal conversion of the tuned NWs surface to ZIF-8 nanomembrane. The microstructure and composition investigations of the ZIF-8/Pd/ZnO nanostructured materials confirmed the presence of both metallic Pd NPs and uniform ZIF-8 thin membrane layer. The integration of these nanomaterials within a miniaturized sensor device enabled the assessment of their performance for H2 detection at concentrations as low as 10 ppm in the presence of various gases such as C6H6, C7H8, C2H5OH, and CH3COCH3. Remarkably high-response signals of 3.2, 4.7, and 6.7 ( Ra/ Rg) have been measured for H2 detection at only 10, 30, and 50 ppm, whereas no noticeable response toward other tested gases was detected, thus confirming the excellent H2 selectivity obtained with such a sensor design. The results obtained showed that the performance of gas sensors toward H2 gas can be greatly increased by both the addition of Pd NPs and the use of ZIF-8 coating, acting as a molecular sieve membrane. Furthermore, the presented strategy could be extended toward the sensing of other species by a judicious choice of both the metallic NPs and MOF materials with tuned properties for specific molecule detection, thus opening a new avenue for the preparation of highly selective sensing devices.

Login to access the Attention Digest and the Sentiment Analysis related to this output.

Timeline Attention over time Attention Score history
Login to access the full charts related to this output.
Activity
Login to access the full charts related to this output.
X Demographics

X Demographics

The data shown below were collected from the profile of 1 X user who shared this research output. Click here to find out more about how the information was compiled.
Mendeley demographics

Mendeley demographics

The data shown below were compiled from readership statistics for 121 Mendeley readers of this research output. Click here to see the associated Mendeley record.
Login to view Mendeley reader trends over time.

Geographical breakdown

Geographical breakdown
Country Count As %
Unknown 121 100%

Demographic breakdown

Readers by professional status
Readers by professional status Count As %
Student > Ph. D. Student 17 14%
Researcher 15 12%
Student > Doctoral Student 9 7%
Student > Master 8 7%
Student > Bachelor 5 4%
Other 10 8%
Unknown 57 47%
Readers by discipline
Readers by discipline Count As %
Chemistry 16 13%
Materials Science 13 11%
Chemical Engineering 9 7%
Physics and Astronomy 5 4%
Engineering 5 4%
Other 5 4%
Unknown 68 56%
Attention Score in Context

Attention Score in Context

This research output has an Altmetric Attention Score of 4. This is our high-level measure of the quality and quantity of online attention that it has received. This Attention Score, as well as the ranking and number of research outputs shown below, was calculated when the research output was last mentioned on 14 September 2021.
All research outputs
#11,321,222
of 33,403,089 outputs
Outputs from ACS Applied Materials & Interfaces
#8,186
of 28,724 outputs
Outputs of similar age
#147,486
of 373,246 outputs
Outputs of similar age from ACS Applied Materials & Interfaces
#199
of 618 outputs
Altmetric has tracked 33,403,089 research outputs across all sources so far. This one has received more attention than most of these and is in the 65th percentile.
So far Altmetric has tracked 28,724 research outputs from this source. They typically receive a little more attention than average, with a mean Attention Score of 5.6. This one has gotten more attention than average, scoring higher than 69% of its peers.
Older research outputs will score higher simply because they've had more time to accumulate mentions. To account for age we can compare this Altmetric Attention Score to the 373,246 tracked outputs that were published within six weeks on either side of this one in any source. This one has gotten more attention than average, scoring higher than 59% of its contemporaries.
We're also able to compare this research output to 618 others from the same source and published within six weeks on either side of this one. This one has gotten more attention than average, scoring higher than 66% of its contemporaries.